MetalworkingFun Forum › Machinery › Lathes v
For the miniature minded....

Thread Modes
For the miniature minded....
nel2lar
Unregistered
 
#17
08-05-2012, 07:28 PM
It is amazing but all the screws ar clockwise threaded. Most screws on a lathe are counter clock. It would have been nicer to be just like a large lathe. Not taking anything from the project, but the man had the skill to make his own taps and screws. That all.
Nelson Collar







May the Lord Direct Your Steps
"When injustice becomes law - resistance becomes duty."
Reply
Thanks given by:


Messages In This Thread
For the miniature minded.... - by Highpower - 07-27-2012, 10:55 AM
RE: For the miniature minded.... - by EdK - 07-27-2012, 11:28 AM
RE: For the miniature minded.... - by doubleboost - 07-27-2012, 12:10 PM
RE: For the miniature minded.... - by DaveH - 07-27-2012, 12:52 PM
RE: For the miniature minded.... - by TomG - 07-27-2012, 01:15 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 06:18 PM
RE: For the miniature minded.... - by DaveH - 07-27-2012, 01:28 PM
RE: For the miniature minded.... - by TomG - 07-27-2012, 01:51 PM
RE: For the miniature minded.... - by EdK - 07-27-2012, 03:54 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 06:36 PM
RE: For the miniature minded.... - by dallen - 07-28-2012, 10:04 AM
RE: For the miniature minded.... - by sasquatch - 07-27-2012, 07:18 PM
RE: For the miniature minded.... - by stevec - 07-27-2012, 07:24 PM
RE: For the miniature minded.... - by EdK - 07-27-2012, 09:42 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 11:44 PM
RE: For the miniature minded.... - by f350ca - 07-27-2012, 10:30 PM
RE: For the miniature minded.... - by nel2lar - 08-05-2012, 07:28 PM
RE: For the miniature minded.... - by Highpower - 08-21-2012, 08:57 AM



Users browsing this thread: 1 Guest(s)