|
Wire clamp tool...
|
08-16-2012, 07:09 AM
Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF
claudef, proud to be a member of Metalworking Forum since Mar 2012.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Wire clamp tool... - by Nitsuj - 08-09-2012, 10:00 PM
RE: Wire clamp tool... - by TOM REED - 08-10-2012, 01:05 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 07:36 AM
RE: Wire clamp tool... - by Highpower - 08-10-2012, 06:12 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 07:42 AM
RE: Wire clamp tool... - by DaveH - 08-10-2012, 08:27 AM
RE: Wire clamp tool... - by TOM REED - 08-10-2012, 08:48 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:38 PM
RE: Wire clamp tool... - by f350ca - 08-10-2012, 09:45 AM
RE: Wire clamp tool... - by ETC57 - 08-10-2012, 05:44 PM
RE: Wire clamp tool... - by stevec - 08-10-2012, 06:42 PM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:41 PM
RE: Wire clamp tool... - by Mayhem - 08-10-2012, 08:11 PM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:51 PM
RE: Wire clamp tool... - by claudef - 08-14-2012, 06:47 PM
RE: Wire clamp tool... - by Highpower - 08-15-2012, 07:17 AM
RE: Wire clamp tool... - by claudef - 08-16-2012, 07:09 AM
RE: Wire clamp tool... - by Highpower - 08-16-2012, 09:36 AM
RE: Wire clamp tool... - by Mayhem - 08-10-2012, 08:36 PM
RE: Wire clamp tool... - by sasquatch - 08-14-2012, 07:26 PM
RE: Wire clamp tool... - by f350ca - 08-14-2012, 09:05 PM
RE: Wire clamp tool... - by mikecwik - 08-14-2012, 09:44 PM
RE: Wire clamp tool... - by DaveH - 08-16-2012, 11:56 AM
|
