MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Home Made 5-C collet chuck

Thread Modes
Home Made 5-C collet chuck
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
#12
08-12-2012, 06:13 PM
Ron
0.0005 run out is great. I re-ground the mating surface on my collet chuck (badly marked from a hard life before me) I improved it but still not that good.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Home Made 5-C collet chuck - by ozzie46 - 08-12-2012, 07:45 AM
RE: Home Made 5-C collet chuck - by dallen - 08-12-2012, 08:17 AM
RE: Home Made 5-C collet chuck - by DaveH - 08-12-2012, 08:29 AM
RE: Home Made 5-C collet chuck - by ozzie46 - 08-12-2012, 08:36 AM
RE: Home Made 5-C collet chuck - by Highpower - 08-12-2012, 09:10 AM
RE: Home Made 5-C collet chuck - by pineyfolks - 08-12-2012, 09:16 AM
RE: Home Made 5-C collet chuck - by EdK - 08-12-2012, 09:27 AM
RE: Home Made 5-C collet chuck - by Mayhem - 08-12-2012, 09:49 AM
RE: Home Made 5-C collet chuck - by TomG - 08-12-2012, 10:19 AM
RE: Home Made 5-C collet chuck - by f350ca - 08-12-2012, 11:30 AM
RE: Home Made 5-C collet chuck - by ozzie46 - 08-12-2012, 02:03 PM
RE: Home Made 5-C collet chuck - by f350ca - 08-12-2012, 06:13 PM



Users browsing this thread: 1 Guest(s)