12-26-2014, 01:36 PM
(12-26-2014, 01:18 PM)f350ca Wrote: After an over indulgent Christmas I got back out to the shop this morn. Started assembling the compound on the lathe a released I could use two proper spanners to set the thrust bearings.
Probably 10 minutes drawing and burning on the plasma table
and there they were. Worked great.
And the lathe is back in good health. The new parts meshed well and the screw turns smooth as glass.
Good
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!