08-26-2015, 01:51 PM
(08-25-2015, 10:48 PM)Highpower Wrote: "Don't know how to weld." Yeah, right....
Some still go wrong All the weld on one side
What I think the main problems were (1) wasn't hot enough - not enough amps, and (2) cleaning - I never bothered to clean the 'mill scale' off before.
This new welding helmet also helps - now I can see where to run the bead and not just guess
The upright angles are 38 x 2mm, the cross pieces 25 x 3 and I did 'blow' two holes through the 2mm angle, other wise it went reasonably well. I ignore the warping
DaveH