03-06-2017, 10:30 PM
I had a bit of time between sleeping in and going to my night shift, made a start on machining a chunk of the forklift tine. I was thinking I might have to anneal it but it cut ok in the bandsaw so I put this lump in the shaper and put a surface on one side.
The piece is 50x130x300mm (around 2"x5"x12") and I was going to surface one of the wide faces but I don't have a vice that will open that wide. Still searching for a shaper vice.
The piece is 50x130x300mm (around 2"x5"x12") and I was going to surface one of the wide faces but I don't have a vice that will open that wide. Still searching for a shaper vice.
Lathe (n); a machine tool used in the production of milling machine components.
Milling Machine (n); a machine tool used in the production of lathe components.
Milling Machine (n); a machine tool used in the production of lathe components.