MetalworkingFun Forum › Machining › General Metalworking Discussion v
Making a threading dial

Thread Modes
Making a threading dial
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#22
09-05-2012, 06:26 PM
(09-05-2012, 07:22 AM)Mayhem Wrote: This lathe was built (from best estimates) between 1890 and 1910. Most likely here in Western Australia by one of the larger mining companies.
Well that certainly explains it, how could anyone build a lathe, upside down, with only a carbide helmet lamp to see by???Slaphead

Sounds like the inception of reverse engineering.Rotfl
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Making a threading dial - by Mayhem - 09-01-2012, 10:44 PM
RE: Making a threading dial - by f350ca - 09-01-2012, 11:56 PM
RE: Making a threading dial - by Mayhem - 09-02-2012, 12:03 AM
RE: Making a threading dial - by TOM REED - 09-02-2012, 01:57 AM
RE: Making a threading dial - by Mayhem - 09-02-2012, 02:20 AM
RE: Making a threading dial - by Tony Wells - 09-02-2012, 02:40 AM
RE: Making a threading dial - by Mayhem - 09-02-2012, 02:48 AM
RE: Making a threading dial - by Hopefuldave - 09-02-2012, 05:35 AM
RE: Making a threading dial - by Highpower - 09-02-2012, 11:24 AM
RE: Making a threading dial - by big job - 09-02-2012, 05:12 AM
RE: Making a threading dial - by Mayhem - 09-02-2012, 06:10 AM
RE: Making a threading dial - by stevec - 09-02-2012, 07:16 AM
RE: Making a threading dial - by Mayhem - 09-02-2012, 08:48 AM
RE: Making a threading dial - by Hopefuldave - 09-02-2012, 12:44 PM
RE: Making a threading dial - by ScrapMetal - 09-02-2012, 02:55 PM
RE: Making a threading dial - by Mayhem - 09-04-2012, 08:16 AM
RE: Making a threading dial - by TOM REED - 09-04-2012, 08:47 AM
RE: Making a threading dial - by SnailPowered - 09-04-2012, 09:59 AM
RE: Making a threading dial - by dallen - 09-04-2012, 10:02 AM
RE: Making a threading dial - by stevec - 09-05-2012, 07:11 AM
RE: Making a threading dial - by Mayhem - 09-05-2012, 07:22 AM
RE: Making a threading dial - by stevec - 09-05-2012, 06:26 PM



Users browsing this thread: 1 Guest(s)