09-07-2012, 04:05 PM
I know I've shown the ER-40 collet chuck in another thread but this thread will document my attempt at getting it installed on the lathe with a reasonable degree of accuracy. I just ordered some of these:
So I can use this:
Now I just need to mate the chuck to the lathe and that's where I'm going to need some help. Questions will be asked once I actually start the project.
Ed
So I can use this:
Now I just need to mate the chuck to the lathe and that's where I'm going to need some help. Questions will be asked once I actually start the project.
Ed