The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › Projects v
Mill power feed

Thread Modes
Mill power feed
dalee Offline
Freshman
**
Posts: 27
Threads: 3
Joined: Aug 2012
Location: Minnesota
#1
09-09-2012, 01:16 PM
Hi,

Just finishing up my homebrew power feed on my G0704 mill. I'm too cheap to pay for a factory unit, ($300 Yikes). So I built my own. I have well under $35 invested. I over payed for paint according my wife.

Power supply
[Image: 2012-09-02192053.jpg]

Drive components
[Image: 2012-09-02192035.jpg]

Drying Paint
[Image: 2012-09-09124802.jpg]

dalee
dalee, proud to be a member of MetalworkingFun since Aug 2012.
Reply
Thanks given by:


Messages In This Thread
Mill power feed - by dalee - 09-09-2012, 01:16 PM
RE: Mill power feed - by doubleboost - 09-09-2012, 02:36 PM
RE: Mill power feed - by stevec - 09-09-2012, 03:14 PM
RE: Mill power feed - by Highpower - 09-09-2012, 03:22 PM
RE: Mill power feed - by krv3000 - 09-09-2012, 05:45 PM
RE: Mill power feed - by dalee - 09-09-2012, 10:56 PM
RE: Mill power feed - by stevec - 09-10-2012, 06:29 AM
RE: Mill power feed - by dalee - 09-10-2012, 10:29 PM



Users browsing this thread: 1 Guest(s)