Cutting Big Holes In Thin Metal
#19
OK, I didn't pick up the brush end in Pix's pic.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Cutting Big Holes In Thin Metal - by doubleboost - 09-11-2012, 03:53 PM
RE: Cutting Big Holes In Thin Metal - by DaveH - 09-11-2012, 04:20 PM
RE: Cutting Big Holes In Thin Metal - by DaveH - 09-11-2012, 04:58 PM
RE: Cutting Big Holes In Thin Metal - by EdK - 09-11-2012, 05:05 PM
RE: Cutting Big Holes In Thin Metal - by stevec - 09-11-2012, 06:25 PM
RE: Cutting Big Holes In Thin Metal - by f350ca - 09-11-2012, 07:22 PM
RE: Cutting Big Holes In Thin Metal - by DaveH - 09-11-2012, 07:25 PM
RE: Cutting Big Holes In Thin Metal - by Mayhem - 09-12-2012, 04:53 AM
RE: Cutting Big Holes In Thin Metal - by PixMan - 09-12-2012, 06:46 AM
RE: Cutting Big Holes In Thin Metal - by stevec - 09-12-2012, 08:29 AM
RE: Cutting Big Holes In Thin Metal - by Mayhem - 09-12-2012, 08:33 AM
RE: Cutting Big Holes In Thin Metal - by DaveH - 09-12-2012, 11:53 AM
RE: Cutting Big Holes In Thin Metal - by stevec - 09-12-2012, 03:49 PM
RE: Cutting Big Holes In Thin Metal - by PixMan - 09-12-2012, 10:19 PM
RE: Cutting Big Holes In Thin Metal - by Micktoon - 09-13-2012, 10:17 AM



Users browsing this thread: 1 Guest(s)