My Imported Welder

[henryarnold]

(09-14-2012, 06:32 AM)EdK Wrote: Thanks Henry. How thick is that steel that you cut with the plasma torch?

Ed

The steel plate was 1/4" thick. I know it looks a little ragged but that's more due to my unsteady hand. The halves were pushed apart so you see the cut. The actual cut is only about 1/16" wide. That was also my first ever cut. The distance of the tip to the plate determines how clean the cut is. I can tell you that with the way it went through 1/4" steel, I could have easily cut up to 1/2" steel.

Henry