MetalworkingFun Forum › Machinery › Lathes v
Request for service - lathe related.

Thread Modes
Request for service - lathe related.
Rickabilly Offline
Junior
****
Posts: 537
Threads: 15
Joined: Jun 2012
Location: Cambridge, England
#30
09-23-2012, 01:33 PM
It does seem counterproductive for a wiper to squeeg off all of the oil doesn't it? at the very least the felt holding some oil just must be better.

Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:


Messages In This Thread
Request for service - lathe related. - by Kaoma - 09-15-2012, 09:49 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 09:27 AM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:20 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:08 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:48 PM
RE: Request for service - lathe related. - by EdK - 09-17-2012, 05:37 AM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 03:49 PM
RE: Request for service - lathe related. - by EdK - 09-22-2012, 08:36 PM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 09:04 AM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 01:00 PM
RE: Request for service - lathe related. - by Rickabilly - 09-23-2012, 01:33 PM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 05:47 PM
RE: Request for service - lathe related. - by EdK - 09-25-2012, 10:23 AM
RE: Request for service - lathe related. - by EdK - 09-25-2012, 11:22 AM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 08:29 AM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 02:31 PM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 05:31 PM
RE: Request for service - lathe related. - by EdK - 09-27-2012, 05:48 AM



Users browsing this thread: 1 Guest(s)