new project
#26
had to make an attachment for the press today so I could press off a part that I shouldn't of pressed on there just yet

[Image: Horozonal-press003.jpg]

[Image: Horozonal-press002.jpg]

[Image: Horozonal-press001.jpg]
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
new project - by dallen - 09-19-2012, 03:13 PM
RE: new project - by DaveH - 09-19-2012, 03:25 PM
RE: new project - by doubleboost - 09-19-2012, 03:32 PM
RE: new project - by Highpower - 09-19-2012, 04:49 PM
RE: new project - by dallen - 09-19-2012, 04:50 PM
RE: new project - by dallen - 09-19-2012, 04:59 PM
RE: new project - by stevec - 09-19-2012, 05:15 PM
RE: new project - by dallen - 09-19-2012, 05:28 PM
RE: new project - by stevec - 09-19-2012, 05:57 PM
RE: new project - by TomG - 09-19-2012, 06:26 PM
RE: new project - by dallen - 09-19-2012, 07:36 PM
RE: new project - by stevec - 09-20-2012, 07:28 AM
RE: new project - by dallen - 09-20-2012, 09:09 AM
RE: new project - by f350ca - 09-20-2012, 09:26 AM
RE: new project - by dallen - 09-20-2012, 11:28 AM
RE: new project - by stevec - 09-20-2012, 02:05 PM
RE: new project - by dallen - 09-24-2012, 02:39 PM
RE: new project - by stevec - 09-24-2012, 02:45 PM
RE: new project - by dallen - 09-24-2012, 07:08 PM
RE: new project - by dallen - 09-25-2012, 06:55 PM
RE: new project - by stevec - 09-25-2012, 06:59 PM
RE: new project - by EdK - 09-25-2012, 07:14 PM
RE: new project - by dallen - 09-25-2012, 07:21 PM
RE: new project - by dallen - 09-26-2012, 09:05 AM
RE: new project - by ETC57 - 09-26-2012, 11:00 AM
RE: new project - by dallen - 09-28-2012, 03:06 PM
RE: new project - by DanH - 09-28-2012, 04:09 PM



Users browsing this thread: 1 Guest(s)