09-23-2012, 07:34 PM
(This post was last modified: 09-23-2012, 07:38 PM by NevadaBlue.)
Nice work!
You make a gasket like that without a lathe by using a gasket hammer. I still have one of the tiny ball-pein gasket hammers, I think the head is about an inch long.
This pic is from the internet, but I have a hammer quite a bit smaller than this one.
![[Image: bmwr512m.jpg]](http://www.benchmarkworks.com/restoration/bmwr512r2_files/bmwr512m.jpg)
You make a gasket like that without a lathe by using a gasket hammer. I still have one of the tiny ball-pein gasket hammers, I think the head is about an inch long.
This pic is from the internet, but I have a hammer quite a bit smaller than this one.
Ken
An old tired/retired/wanna-be machinist.
An old tired/retired/wanna-be machinist.