Flat wrenches
#8
(09-26-2012, 03:26 PM)Wawoodman Wrote: Ed,
Could you post a link to Bob's post?

Sorry Mike. Bob does not have a mill so he does a lot of his shaping with a file and does a fantastic job. I was just referring to Bob's expertise on using a file and not suggesting any particular post of his to refer to.

Ed
Reply
Thanks given by:


Messages In This Thread
Flat wrenches - by Wawoodman - 09-26-2012, 09:11 AM
RE: Flat wrenches - by EdK - 09-26-2012, 09:54 AM
RE: Flat wrenches - by dallen - 09-26-2012, 10:16 AM
RE: Flat wrenches - by Wawoodman - 09-26-2012, 12:19 PM
RE: Flat wrenches - by EdK - 09-26-2012, 02:25 PM
RE: Flat wrenches - by dallen - 09-26-2012, 12:52 PM
RE: Flat wrenches - by Wawoodman - 09-26-2012, 03:26 PM
RE: Flat wrenches - by EdK - 09-26-2012, 05:26 PM
RE: Flat wrenches - by TomG - 09-26-2012, 09:30 PM
RE: Flat wrenches - by Wawoodman - 09-27-2012, 09:32 AM
RE: Flat wrenches - by TomG - 09-27-2012, 10:02 AM
RE: Flat wrenches - by stevec - 09-27-2012, 07:10 AM
RE: Flat wrenches - by EdK - 09-27-2012, 07:19 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 11:13 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:24 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 11:40 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:51 AM
RE: Flat wrenches - by dallen - 09-27-2012, 11:55 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:57 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 12:10 PM



Users browsing this thread: 1 Guest(s)