|
Adding power to the z-axis
|
|
10-07-2012, 09:26 AM
Excellent! Is that usable for really minor up and down, as well as the long travel? I. E., for adjusting the Z by .010 or .015? I would love to mechanize the knee on my Rockwell.
Also, I'm curious about the gas lift. I can see that it makes going up easier, but doesn't it make going down, harder? |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Adding power to the z-axis - by DanH - 10-06-2012, 12:30 PM
RE: Adding power to the z-axis - by DanH - 10-06-2012, 12:56 PM
RE: Adding power to the z-axis - by EdK - 10-06-2012, 01:06 PM
RE: Adding power to the z-axis - by DanH - 10-06-2012, 01:31 PM
RE: Adding power to the z-axis - by Highpower - 10-06-2012, 08:45 PM
RE: Adding power to the z-axis - by DanH - 10-06-2012, 09:05 PM
RE: Adding power to the z-axis - by Wawoodman - 10-07-2012, 09:26 AM
RE: Adding power to the z-axis - by DanH - 10-07-2012, 01:52 PM
RE: Adding power to the z-axis - by TomG - 10-07-2012, 09:44 AM
RE: Adding power to the z-axis - by dallen - 10-07-2012, 10:05 AM
RE: Adding power to the z-axis - by DanH - 10-07-2012, 01:57 PM
RE: Adding power to the z-axis - by petertha - 10-20-2012, 08:48 PM
RE: Adding power to the z-axis - by DanH - 10-20-2012, 09:43 PM
|
