Minimal Clockmaking
I'm watching intently Brian, since I want to do the same thing with my Stevens. Popcorn

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Brian,
Really is a labour of luv
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
OK Dave you can stop fretting, I have just finished the section on the use of the mill and this is the indexing attachment.
    .
The book so far has 19,402 words--300 photos and 83 drawings.
Not long now.
Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Well, it's about time you got back to work! Big Grin It sounds like you've made some progress on the plans book.

Hopefully you had a nice holiday.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Welcome back Brian Thumbsup
I wondered where you had gone Big Grin
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
I am just putting the book together and doing the index etc .and i have a few spaces in the text that i want to fill with photos of safety posters or machine warnings etc Old--New--- Funny-- Military.

can you helpSmiley-dancenana
Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Thumbsup Its all done and dusted all 337 pages of it 325 photos & 85 drawings.Rotfl
Printed in a type size that is readable, with separate down loadable plans for workshop use at the end of each section.including all the tools.
The cost is 20£ . and i will down load by return.
Ee me for details http://www.magicbrian40@yahoo.com
Or in this thread.
BrianDrinks
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
It sounds like you put a lot of work into it Brian. Congratulations on finishing it up. Thumbsup

Will there be a preview of the book on your website?

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Hi Tom
Just getting my breath back after all the work, it took far more time than I expected to get it just right. I hope it will help people to get a start into making chips, and end up with something to be proud of, without spending lots of cash
Yes more on the web site later but for now a few beers, its been eleven and a half months in the making.
Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Brian,
Good job well done. Thumbsup
Have a bit of a rest now Rotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)