MetalworkingFun Forum › Machining › Projects v
razor

Thread Modes
razor
mattinker Offline
Freshman
**
Posts: 30
Threads: 3
Joined: Jan 2013
Location: Paris, France
#12
03-01-2013, 11:57 AM (This post was last modified: 03-01-2013, 01:00 PM by EdK.)
TomG Wrote:I've always wanted to try shaving with a blade but so far haven't been able to muster up the courage.
Tom
I don't know where I heard it but, apprentice barbers "shaved" soap of an inflated balloon, when they could do it without it bursting the balloon, they were allowed to shave humans!

Regards, Matthew
mattinker, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
razor - by dallen - 12-23-2012, 08:01 PM
RE: razor - by sasquatch - 12-23-2012, 08:22 PM
RE: razor - by dallen - 12-23-2012, 08:32 PM
RE: razor - by dallen - 12-25-2012, 01:04 PM
RE: razor - by dallen - 12-26-2012, 08:25 AM
RE: razor - by the artfull-codger - 02-25-2013, 04:52 PM
RE: razor - by dallen - 02-27-2013, 02:10 PM
RE: razor - by TomG - 02-28-2013, 08:15 AM
RE: razor - by mattinker - 03-01-2013, 11:57 AM
RE: razor - by dallen - 02-28-2013, 01:49 PM
RE: razor - by dallen - 02-28-2013, 04:02 PM
RE: razor - by TomG - 02-28-2013, 05:52 PM
RE: razor - by TomG - 03-01-2013, 01:28 PM
RE: razor - by dallen - 03-01-2013, 01:37 PM
RE: razor - by Tony Wells - 03-10-2013, 09:47 PM
RE: razor - by the artfull-codger - 03-15-2013, 03:21 PM
RE: razor - by dallen - 03-11-2013, 08:50 PM
RE: razor - by Tony Wells - 03-15-2013, 09:33 PM
RE: razor - by DaveH - 03-16-2013, 02:53 PM
RE: razor - by Tony Wells - 03-18-2013, 08:46 AM
RE: razor - by dallen - 03-22-2013, 03:59 PM
RE: razor - by TomG - 03-23-2013, 02:47 PM
RE: razor - by EdK - 03-23-2013, 02:49 PM
RE: razor - by TomG - 03-23-2013, 03:00 PM
RE: razor - by EdK - 03-23-2013, 03:36 PM
RE: razor - by TomG - 03-23-2013, 03:59 PM
RE: razor - by dallen - 03-23-2013, 05:12 PM
RE: razor - by EdK - 03-23-2013, 05:15 PM
RE: razor - by dallen - 03-23-2013, 05:49 PM
RE: razor - by EdK - 03-23-2013, 07:14 PM



Users browsing this thread: 1 Guest(s)