MetalworkingFun Forum › Machining › Projects v
razor

Thread Modes
razor
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#27
03-23-2013, 05:12 PM (This post was last modified: 03-23-2013, 05:13 PM by dallen.)
nice looking razor. I shaved with the on in the last picture I posted this morning it still needs some more time on the stone to be sharp.

at the moment I'm eagerly awaiting the arrival of this, looks sorta rough but at 125 years old I probably will also

   
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
razor - by dallen - 12-23-2012, 08:01 PM
RE: razor - by sasquatch - 12-23-2012, 08:22 PM
RE: razor - by dallen - 12-23-2012, 08:32 PM
RE: razor - by dallen - 12-25-2012, 01:04 PM
RE: razor - by dallen - 12-26-2012, 08:25 AM
RE: razor - by the artfull-codger - 02-25-2013, 04:52 PM
RE: razor - by dallen - 02-27-2013, 02:10 PM
RE: razor - by TomG - 02-28-2013, 08:15 AM
RE: razor - by mattinker - 03-01-2013, 11:57 AM
RE: razor - by dallen - 02-28-2013, 01:49 PM
RE: razor - by dallen - 02-28-2013, 04:02 PM
RE: razor - by TomG - 02-28-2013, 05:52 PM
RE: razor - by TomG - 03-01-2013, 01:28 PM
RE: razor - by dallen - 03-01-2013, 01:37 PM
RE: razor - by Tony Wells - 03-10-2013, 09:47 PM
RE: razor - by the artfull-codger - 03-15-2013, 03:21 PM
RE: razor - by dallen - 03-11-2013, 08:50 PM
RE: razor - by Tony Wells - 03-15-2013, 09:33 PM
RE: razor - by DaveH - 03-16-2013, 02:53 PM
RE: razor - by Tony Wells - 03-18-2013, 08:46 AM
RE: razor - by dallen - 03-22-2013, 03:59 PM
RE: razor - by TomG - 03-23-2013, 02:47 PM
RE: razor - by EdK - 03-23-2013, 02:49 PM
RE: razor - by TomG - 03-23-2013, 03:00 PM
RE: razor - by EdK - 03-23-2013, 03:36 PM
RE: razor - by TomG - 03-23-2013, 03:59 PM
RE: razor - by dallen - 03-23-2013, 05:12 PM
RE: razor - by EdK - 03-23-2013, 05:15 PM
RE: razor - by dallen - 03-23-2013, 05:49 PM
RE: razor - by EdK - 03-23-2013, 07:14 PM



Users browsing this thread: 2 Guest(s)