X2 CNC Conversion

Thread Modes

X2 CNC Conversion

Hawkeye Offline

Junior

Posts: 531
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada

02-07-2013, 09:26 PM

The ballscrews are Chinese 1605. 5mm pitch, or 5.08 turns per inch. My advisor has me tuned down to 2 microsteps - 0.9* per step.

Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.

« Next Oldest | Next Newest »

Messages In This Thread

X2 CNC Conversion - by Hawkeye - 01-22-2013, 12:40 AM

RE: X2 CNC Conversion - by Mayhem - 01-22-2013, 08:08 AM

RE: X2 CNC Conversion - by DaveH - 01-22-2013, 01:22 PM

RE: X2 CNC Conversion - by Hawkeye - 01-22-2013, 09:38 PM

RE: X2 CNC Conversion - by Hawkeye - 01-31-2013, 11:48 PM

RE: X2 CNC Conversion - by Hawkeye - 02-06-2013, 11:04 PM

RE: X2 CNC Conversion - by f350ca - 02-06-2013, 11:57 PM

RE: X2 CNC Conversion - by Hawkeye - 02-07-2013, 09:26 PM

RE: X2 CNC Conversion - by f350ca - 02-07-2013, 11:04 PM

RE: X2 CNC Conversion - by Hawkeye - 02-08-2013, 10:35 PM

RE: X2 CNC Conversion - by dallen - 02-15-2013, 10:06 PM

RE: X2 CNC Conversion - by Hawkeye - 02-17-2013, 11:07 AM

RE: X2 CNC Conversion - by Hawkeye - 09-30-2017, 10:56 PM

RE: X2 CNC Conversion - by rleete - 11-12-2020, 10:51 AM

RE: X2 CNC Conversion - by Hawkeye - 11-12-2020, 11:38 PM

Users browsing this thread: 2 Guest(s)