Fire Wood Processor
#71
Couldn't get it to add another picture.
This is the length of the log holder, and the roller chain on the floor.
[Image: IMG_1650.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#72
I have to say you don't do things by halves. Smile 
Smiley-eatdrink004 
DaveH 
Reply
Thanks given by:
#73
Picked up the golden bronze yesterday. Glad the 2 inch shd 160 pipe I used for the housings limited the OD of the bushings. They measured up 30 thou over on the OD and 30 thou under on the ID, perfect for fitting.

[Image: IMG_1651.jpg]

Pressed in ready to be bored.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#74
Are you planning on installing grease nipples?
Reply
Thanks given by:
#75
Next step Al, should I cut a grove either side of the hole to spread the grease? 

I posted this picture earlier but it seams to have disappeared.
Got the bushings bored and the shafts made up.

[Image: IMG_1653.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#76
Nice-looking work.

Funny you ask that question. I just read something on that subject in one of the Lindsay Books "Tips & Tricks of Old-Time Machinists". Fun read - 5 book set for $24.

I'll look it up and give you the answer soon. The Readers Digest version of it was that the design of the grooves depends on rotation.
Reply
Thanks given by:
#77
Set up a jig to hold the grouser parts when welding. Made a block to go between the angle irons to give the correct spacing for the chain.

[Image: IMG_1654.jpg]

Then used the same jig to hold them on the plasma table for profiling.

[Image: IMG_1657.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#78
Have the side rails of the frame welded now and the bearings fitted. As expected had to scrape the bearings after I bolted them up to the welded side rails. Broke the chain into 2 foot sections and joined it back with the grousers.

[Image: IMG_1658.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#79
Man that looks great! Thumbsup
Reply
Thanks given by: f350ca
#80
[Image: IMG_1658.jpg]

Looking at this I'm surprised that mule doesn't have tracks on it!    Big Grin

Honestly Greg, do you ever sleep?   Rotfl

(I'm just jealous because I don't have 1/100th of your energy.)  Smiley-signs131
Willie
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)