Advice taken Steve, even if I read your last post after the fact. Bolted up to the four jaw body,
![[Image: IMG_0515.jpg]](https://lh5.googleusercontent.com/-lT_-taBv80Q/UUZk8GnKK8I/AAAAAAAABJw/3hpvPdd91zE/s1280/IMG_0515.jpg)
The photo doesn't do the setup justice. They're 3 1/3 bores about a 2 inch boring bar and an 18 inch chuck, just cleared the saddle. Ran it at 100 rpm and .004 thou/rev feed. Not a great surface but should hone out fine. We're .0185 over now. Bore spec is 3.250 - 3.249 so we have .0015 to play with while honing, shooting for .0005 with the hone.
The photo doesn't do the setup justice. They're 3 1/3 bores about a 2 inch boring bar and an 18 inch chuck, just cleared the saddle. Ran it at 100 rpm and .004 thou/rev feed. Not a great surface but should hone out fine. We're .0185 over now. Bore spec is 3.250 - 3.249 so we have .0015 to play with while honing, shooting for .0005 with the hone.
Free advice is worth exactly what you payed for it.
Greg
Greg