02-09-2016, 12:16 AM
Just to get you guys off politics for Ed.
I need a transfer case to drive the two pumps, which won't take a side load and the clutch for the saw.
This will have two shafts with a chain drive between them, the chain drive will step the 2800 rpm engine speed to 3600 for the saw clutch.
Here the welded up case is sitting on 3 points so as not to twist it while I flatten the mating surface where the cover which will carry the two other bearings bolts.
![[Image: IMG_2044.jpg]](https://lh3.googleusercontent.com/-ggiN5e89H9o/VrlzmBe9zDI/AAAAAAAADlg/oTepT7Znhss/s1280-Ic42/IMG_2044.jpg)
Being a steel weldament it loves to ring, couldn't use my indexable face mill, it sang and gave a glazed surface when it tried to cut it. Had to use a fly cutter, slow job taking light cuts to remove the .060 it needed to flatten it out.
I need a transfer case to drive the two pumps, which won't take a side load and the clutch for the saw.
This will have two shafts with a chain drive between them, the chain drive will step the 2800 rpm engine speed to 3600 for the saw clutch.
Here the welded up case is sitting on 3 points so as not to twist it while I flatten the mating surface where the cover which will carry the two other bearings bolts.
Being a steel weldament it loves to ring, couldn't use my indexable face mill, it sang and gave a glazed surface when it tried to cut it. Had to use a fly cutter, slow job taking light cuts to remove the .060 it needed to flatten it out.
Free advice is worth exactly what you payed for it.
Greg
Greg