Fire Wood Processor

[f350ca]

Got the oiler for the chain saw working so it was time for a proper test. 
The log deck still needed the chain on the centre bunk, once it was installed the logs feed properly.
The chute the log drops into still needs planking to centre the log when it rolls in.
The feed chain on the log chute is too slow, will have to change the ratio on the drive chain to sort that out.
The saw works great, I was worried the single belt drive would slip but that isn't an issue at all. In fact I managed to clamp the log too tight and bound the saw, it will stall the engine.
The cut block hangs up on the saw guard as it rolls over to the splitter. Not sure there is much I can do about that. Not a huge issue, think I can live with it.
The splitter is great. Fast and powerful. As you can see 30 inch long oak blocks are pretty much a joke for it.
All in all I'm pleased.
Couple of little things to finish up and we should be painting it latter
this week.

https://www.youtube.com/watch?v=ovAi-dd0dKY

Thanks for watching