New Log Splitter
Nah Greg, I haven't gotten around to making a four or 6 way wedge, the diameters of the wood I process vary too much and the switch out of the wedge can become a bit of a hassle.
I do a LOT of smaller dia. stuff. Some times I stack 2 for a 4 piece output with one stroke.

I think you spelled "wright"  rong. Blush  Rotfl

Steve

Smiley-eatdrink004  
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by: f350ca
Hi Steve 

Just wondering  in these photos ( the three below ) showing your welds , did you take the photos before or after the slag was removed ?

[Image: P1010035_zpszoktf7b1.jpg]
[Image: P1010037_zpsk3fdw6jj.jpg]
[Image: Log%20lifter%20amp%20Cyl_zpse7yfl69s.jpg]


Also was the cutter  blunt when you machined this part ?  just the finish looks a bit on the poor side . I mean ruff looking . 

[Image: 45%20deg%20tool_zpsdtgt3cnr.jpg]



Kind regards Rob
Reply
Thanks given by:
Rob, am I supposed to REMOVE the slag? Doesn't it just fall off shortly after painting? 17428

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
I suppose painting over your welds dose hide a multitude of sins.

Rob
Reply
Thanks given by:
Yes it DOES, until it falls off with the slag. Blush

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)