Cross slide lock with a DRO fitted
#19
(04-05-2013, 07:59 PM)EdK Wrote: So it looks like I should add the brass plugs to my mill. Shows you how much I know about machine design. I suppose it was a cost savings to the manufacturer to not put those in.

Ed

Mild steel will do Ed, it will probably be better if your using a ball bearing as it wont dent or distort as easy as brass.

Dave
Reply
Thanks given by: EdK


Messages In This Thread
Cross slide lock with a DRO fitted - by Dave J - 04-05-2013, 05:44 AM
RE: Cross slide lock with a DRO fitted - by DaveH - 04-05-2013, 07:54 AM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 08:23 AM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 11:50 AM
RE: Cross slide lock with a DRO fitted - by DaveH - 04-05-2013, 01:01 PM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 02:23 PM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 04:07 PM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 06:28 PM
RE: Cross slide lock with a DRO fitted - by DaveH - 04-05-2013, 07:34 PM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 07:59 PM
RE: Cross slide lock with a DRO fitted - by Dave J - 04-05-2013, 09:32 PM



Users browsing this thread: 1 Guest(s)