a big D.T.I refit
#11
Nice job
Way to small for my fingers
GraemlinGraemlin
John
Reply
Thanks given by:
#12
"too small" John "too".
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#13
thanks all for the comments john stop hitting them with the hammer then any way last bit it needed a end so i had a rummage and fawned this its a stand off used in computers to mount the curcet board i drilled the bottom out to 3.4 by 1.7 for a 3.5 ball to go in and put a angel on the front then drilled 1.6 for a m2 tap i mixed up sum epoxy and preset the ball in and screed in a length of 2mm studding left it to go hard then gave it a buff up right pics


Attached Files Thumbnail(s)
                           
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#14
As always Graemlin

Ed
Reply
Thanks given by:
#15
Agreed, great fix Bob.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)