Adjusting/setting up a bandsaw
#21
   
Willie
Reply
Thanks given by: Mayhem
#22
Here is a better view of the wire wheel set-up:

   
Willie
Reply
Thanks given by: Mayhem
#23
Here you go Darren.

The article: http://www.machinistblog.com/a-chip-brus...6-bandsaw/

The plans: http://www.machinistblog.com/downloads/A...andsaw.pdf

That project has been on my list for quite awhile now. I even bought the brushes for it but have just not gotten around to making the modification.

Ed
Reply
Thanks given by: Mayhem
#24
This is how I did it.

[Image: attachment.php?thumbnail=218]
Smiley-eatdrink004
DaveH
Reply
Thanks given by: Mayhem
#25
Dave, did you make that bracket? It looks like a factory made part.
Willie
Reply
Thanks given by:
#26
Willie & DaveH, thanks for the circular brush idea. It's now on my list (my long, long list, sigh).
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#27
(06-10-2013, 04:48 PM)Highpower Wrote: Dave, did you make that bracket? It looks like a factory made part.
Sure did, Smiley-dancenana I assume you meant it as a compliment Rotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#28
DaveH, I'm sure he meant "non Asian factory made". Rotfl
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#29
(06-10-2013, 07:28 PM)stevec Wrote: DaveH, I'm sure he meant "non Asian factory made". Rotfl

Good point Steve! I guess I should have said it looks TOO good to be a factory part in that case. Rotfl

It's obviously a heavier bracket than what is on my saw. Blush

Smiley-signs107
Willie
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)