06-29-2013, 02:54 PM
(06-29-2013, 02:30 PM)stevec Wrote: Ed, I think those studs are the infamous 10mm fine thread "setscrews" that are hard to find, I imagine, the nuts would be too.
I still use mine, if you lock the nuts up tight to the knurled adjusting nuts they hold ok, but they're a pita to adjust.
When I get around to making my holders (if I ever get a round toit) they'll have good ole Holochrome UNF screws.
Steve,
You are correct, they're M10x1.0 threaded. Luckily those set screws are all OK. It's the nuts that are all tapped kiddie wampus. McMaster has the regular M10x1.0 nuts but not the thumb nuts. I'll have to make the thumb nuts. I'll make them out of brass. I don't have a knurling tool so they won't be anything fancy.
Ed