MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
More New Tool Holders

Thread Modes
More New Tool Holders
Highpower Offline
JAFO
******
Posts: 4,369
Threads: 178
Joined: Feb 2012
Location: Missouri, USA
#18
06-29-2013, 08:52 PM
(06-29-2013, 02:54 PM)EdK Wrote: Luckily those set screws are all OK.

Ed

Ahhh, but I'll bet you haven't tried tightening them down on a tool yet, am I right? Big Grin

The last batch I got from CDCO the hex rounded out in half of them on the first tightening. Now I just bin them straight out of the box and keep a large bag of set screws and studs on hand from McMaster as replacements.

I also chase all the threads in the holders before installing the new hardware. It's like a rock quarry down in those holes. Bleh
tools4cheap is looking better all the time.
Willie
Reply
Thanks given by:


Messages In This Thread
More New Tool Holders - by EdK - 06-12-2013, 05:48 PM
RE: New Tool Holder - by aametalmaster - 06-12-2013, 05:57 PM
RE: New Tool Holder - by EdK - 06-12-2013, 06:07 PM
RE: New Tool Holder - by the penguin - 06-12-2013, 06:11 PM
RE: New Tool Holder - by EdK - 06-12-2013, 06:19 PM
RE: More New Tool Holders - by Highpower - 06-12-2013, 10:52 PM
RE: New Tool Holder - by aametalmaster - 06-12-2013, 06:11 PM
RE: New Tool Holder - by DaveH - 06-12-2013, 06:20 PM
RE: New Tool Holder - by EdK - 06-12-2013, 06:23 PM
RE: More New Tool Holders - by Dave J - 06-13-2013, 02:26 AM
RE: More New Tool Holders - by EdK - 06-13-2013, 05:44 AM
RE: More New Tool Holders - by Mayhem - 06-13-2013, 06:05 AM
RE: More New Tool Holders - by EdK - 06-29-2013, 10:52 AM
RE: More New Tool Holders - by stevec - 06-29-2013, 02:30 PM
RE: More New Tool Holders - by EdK - 06-29-2013, 02:54 PM
RE: More New Tool Holders - by Highpower - 06-29-2013, 08:52 PM
RE: More New Tool Holders - by EdK - 06-30-2013, 08:49 AM
RE: More New Tool Holders - by the penguin - 06-29-2013, 04:29 PM
RE: More New Tool Holders - by EdK - 06-29-2013, 04:46 PM
RE: More New Tool Holders - by stevec - 06-30-2013, 06:09 AM
RE: More New Tool Holders - by Highpower - 06-30-2013, 09:34 AM



Users browsing this thread: 1 Guest(s)