How to Wind a Coil Spring on the Metal Lathe
#24
(06-25-2013, 06:45 PM)TomG Wrote: Thanks Dave.

No joy on the spring programs Ed. Neither one would run.

Tom

Tom,

I was afraid of that. I've tried running some of the other programs in the past and have not had much luck. They were all written too long ago to work with the newer operating systems. If I had the source code I could rewrite them in a more recent version of a programming language.

Ed
Reply
Thanks given by:


Messages In This Thread
RE: How to Wind a Coil Spring on the Metal Lathe - by EdK - 06-25-2013, 06:58 PM



Users browsing this thread: 2 Guest(s)