Grizzly G9972Z gets delivered tomorrow
#21
(12-11-2013, 04:22 PM)marfaguy Wrote:
(12-11-2013, 03:19 PM)EdK Wrote: If 220 volts is a problem, and even if it isn't, this Precision Matthews lathe has a bunch of nice features. A separate feed rod rather than using the half nuts for feeding is a nice feature. Variable speed on the fly and a tachometer are a couple more.

http://www.machinetoolonline.com/PM-1127-VF.html

Ed

Those are nice. I remember looking at those and now I can't remember why I chose the Grizzly over one of them. I do remember there was a reason, I just can't remember what it was.

It might have been the increase in cost or more likely he didn't have any in stock at the time. I can't see any reason why the Grizzly would be better as far as specs go. Smiley-gen163

Ed
Reply
Thanks given by:


Messages In This Thread
RE: Grizzly G9972Z gets delivered tomorrow - by EdK - 12-11-2013, 04:37 PM



Users browsing this thread: 1 Guest(s)