Power Crossfeed for Asian 9X20s
#1
Gonna give this a shot. Tom G helped me with what I needed Thanks Tom.

It will be a right angle drive DC motor 28 volts 80 RPM. Power supply 120 AC to 28 DC. Variable speed unit with reverse. To free wheel for manual use a dog clutch will be at the drive wheel.

Pic #1 parts the have arrived power supply and speed control.

Pic #2 parts from radio shack.

"Billy G"


Attached Files Thumbnail(s)
       
Reply
Thanks given by:
#2
6820

Looking forward to seeing this project Bill. Cool
Willie
Reply
Thanks given by:
#3
I've wanted the power option for some time Willie. I started thinking of using a stepper motor. Tom stepped up to the plate with this idea after we settled on the motor. From there it was just wait for parts.

"Billy G"
Reply
Thanks given by:
#4
Yeah, the waiting is always the hardest part. Big Grin
Willie
Reply
Thanks given by:
#5
I'll be watching this with interest, as I'm going to be helping a friend do this to his lathe.
Hunting American dentists since 2015.
Reply
Thanks given by:
#6
I needed 4 standoffs for the speed control board. They are 3/16 hex brass with 6-32 male and female threads. They are 1/2 inch long.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#7
Should have something to show this evening. I am no electrician and it's slow going. I would like to have it all wired except for the motor this evening. Buuuuuuut .........................

"Billy G"
Reply
Thanks given by:
#8
Not much, just the speed control and switches mounter. Will get the power supply in tomorrow.

"Billy G"


Attached Files Thumbnail(s)
       
Reply
Thanks given by:
#9
Today we try to get it all in there leaving us with just connecting the motor when it arrives. Then the machining begins with the Dog Clutch. It will be a simple push pull configuration.

"Billy G"
Reply
Thanks given by:
#10
Need the power cord and motor. The electrical components are in. Left switch is for direction. Center switch speed control. Right switch power on/off.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)