How to Mill a Part That is Too Thin to Mill

Thread Modes

How to Mill a Part That is Too Thin to Mill

oldgoaly Offline

Junior

Posts: 251
Threads: 21
Joined: Jun 2013
Location: Shiloh, Il. USA

07-21-2013, 07:23 PM

Tom,
long time ago I got a variety of shim stock from enco, back when it was American made, plus from a swap met there are a few rolls of brass shim stock. In aluminum I have is 3003 .063, .050, .040, there may be a pc of .030 left. something in between? how about galvaneal (no longer galvanized) .060 to .015 16 to 28 gauge. Guess I'm just a scrounger!

oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

How to Mill a Part That is Too Thin to Mill - by TomG - 07-21-2013, 06:03 PM

RE: How to Mill a Part That is Too Thin to Mill - by EdK - 07-21-2013, 06:14 PM

RE: How to Mill a Part That is Too Thin to Mill - by oldgoaly - 07-21-2013, 06:32 PM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-21-2013, 06:45 PM

RE: How to Mill a Part That is Too Thin to Mill - by EdK - 07-21-2013, 06:48 PM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-21-2013, 06:56 PM

RE: How to Mill a Part That is Too Thin to Mill - by oldgoaly - 07-21-2013, 07:23 PM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-21-2013, 07:29 PM