Fly cutter project!!!
#1
I found some time today and made a small fly cutter for gear making, arbors are made a couple of days ago. Now I have to cut a 1/4" HSS cutter to fit a gear profile. I thought I would start off with a small gear to try, since I do not have any big material to use for now. Now I just have to pic a gear to try out and start cutting. I do have to go to the store to buy a set screw, I thought I had some but they were all to big. I made the fly cutter to fit my Sherline Mill and the arbor to fit the rotary table and chuck. The stem does not show up on the pic, but I made it fit the holder in the mill.
Paul


Attached Files Thumbnail(s)
   
pjf134, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#2
HI it looks good so far
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)