Making A Spring
#4
Smiley-signs028

How do you guys figure out the TPI you need to use when you need a specific length with a specific number of coils? I need to make one of these:

Quote:Spring length - .675"
Spring EXT. Diameter - .15"
Spring INT. Diameter - .08"
1/16" drill bit mandrel
10 coils of .032" wire
Willie
Reply
Thanks given by:


Messages In This Thread
Making A Spring - by EdK - 07-27-2013, 05:23 PM
RE: Making A Spring - by oldgoaly - 07-27-2013, 06:02 PM
RE: Making A Spring - by EdK - 08-02-2013, 03:18 PM
RE: Making A Spring - by Highpower - 08-02-2013, 04:14 PM
RE: Making A Spring - by EdK - 08-02-2013, 05:02 PM
RE: Making A Spring - by TomG - 08-02-2013, 04:31 PM
RE: Making A Spring - by oldgoaly - 08-02-2013, 04:57 PM
RE: Making A Spring - by EdK - 08-02-2013, 05:04 PM
RE: Making A Spring - by Mayhem - 08-03-2013, 09:59 AM
RE: Making A Spring - by dallen - 08-03-2013, 10:32 AM
RE: Making A Spring - by EdK - 08-03-2013, 10:42 AM
RE: Making A Spring - by oldgoaly - 08-03-2013, 11:21 AM
RE: Making A Spring - by DaveH - 08-03-2013, 11:53 AM
RE: Making A Spring - by EdK - 08-03-2013, 12:33 PM
RE: Making A Spring - by DaveH - 08-03-2013, 02:51 PM
RE: Making A Spring - by allrite - 02-26-2014, 04:50 PM
RE: Making A Spring - by EdK - 02-26-2014, 04:59 PM
RE: Making A Spring - by TomG - 02-26-2014, 06:51 PM
RE: Making A Spring - by f350ca - 02-26-2014, 08:13 PM
RE: Making A Spring - by allrite - 02-27-2014, 12:33 PM
RE: Making A Spring - by stevec - 02-28-2014, 07:04 AM



Users browsing this thread: 1 Guest(s)