Thread Cutting on the Lathe, Part Two - Grinding the Tool

Hello There, Guest! Register

Thread Modes

Thread Cutting on the Lathe, Part Two - Grinding the Tool

TomG Offline

Offline

Alt. Whipping Boy

Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan

The following 1 user Likes TomG's post:
EdK (08-04-2013)

#9

08-04-2013, 02:44 PM

The new video is up and as an added bonus it's now available in HD. The mistake is corrected, now if I could just do something about the narrator.

Smiley-think005

Tom

Reply

Thanks given by: PixMan

« Next Oldest | Next Newest »

Messages In This Thread

Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 07-28-2013, 08:41 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by b4dyc - 07-29-2013, 08:23 AM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 07-29-2013, 08:33 AM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by f350ca - 07-29-2013, 12:17 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 07-29-2013, 12:24 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by DaveH - 08-02-2013, 11:28 AM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by PixMan - 08-03-2013, 10:11 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 08-03-2013, 10:54 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 08-04-2013, 02:44 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by doubleboost - 08-04-2013, 03:09 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by dallen - 08-04-2013, 03:03 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 08-04-2013, 03:11 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by PixMan - 08-04-2013, 05:48 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by stevec - 08-05-2013, 05:58 AM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by dallen - 08-05-2013, 08:25 PM

Users browsing this thread: 1 Guest(s)