Thread Cutting on the Lathe, Part Two

Thread Modes

Thread Cutting on the Lathe, Part Two - Grinding the Tool

stevec Offline

69 yr. old senior

Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada

#14

08-05-2013, 05:58 AM

I thought I understood that ANY cutting tool should have some form of radius on the tip. The reason being if you start cutting with a "sharp" tip on the tool it'll try to make it's own flat or radius, not a good thing. Rotfl

Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 07-28-2013, 08:41 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by b4dyc - 07-29-2013, 08:23 AM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 07-29-2013, 08:33 AM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by f350ca - 07-29-2013, 12:17 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 07-29-2013, 12:24 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by DaveH - 08-02-2013, 11:28 AM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by PixMan - 08-03-2013, 10:11 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 08-03-2013, 10:54 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 08-04-2013, 02:44 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by doubleboost - 08-04-2013, 03:09 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by dallen - 08-04-2013, 03:03 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by TomG - 08-04-2013, 03:11 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by PixMan - 08-04-2013, 05:48 PM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by stevec - 08-05-2013, 05:58 AM

RE: Thread Cutting on the Lathe, Part Two - Grinding the Tool - by dallen - 08-05-2013, 08:25 PM

Users browsing this thread: 1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me