Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
A question Ed, if you don't mind what did it cost you to rebuild the head. I don't plan on tearing mine down its not leaking but may look into gathering up the parts to have on hand for a rainy day project to put in a better grade of bearings, and then you never know it may crap out tomorrow and need rebuilding.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
Posts: 8,739
Threads: 313
Joined: Feb 2012
Location: Arizona/Minnesota
(09-17-2012, 08:42 AM)dallen Wrote: A question Ed, if you don't mind what did it cost you to rebuild the head. I don't plan on tearing mine down its not leaking but may look into gathering up the parts to have on hand for a rainy day project to put in a better grade of bearings, and then you never know it may crap out tomorrow and need rebuilding.
DA,
I'm guessing it was around $300. You wouldn't need to replace all of the bearings like I did. All of the smaller bearings seemed to be in good shape and there are a lot of them. Hope this helps.
Ed
