MetalworkingFun Forum › Machinery › Lathes v
Getting carried away

Thread Modes
Getting carried away
EdK Offline
Whipping Boy
*******
Posts: 8,749
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#12
04-18-2014, 12:52 PM
Reviving an old thread.

Dave,

So I assume you used the horizontal spindle on your mill to do the grinding. Is that correct?

Thanks,
Ed
Reply
Thanks given by:


Messages In This Thread
Getting carried away - by Dave J - 08-15-2013, 09:17 PM
RE: Getting carried away - by TomG - 08-15-2013, 10:57 PM
RE: Getting carried away - by Dave J - 08-16-2013, 12:57 AM
RE: Getting carried away - by Dave J - 08-16-2013, 01:09 AM
RE: Getting carried away - by EdK - 08-16-2013, 06:22 AM
RE: Getting carried away - by Dave J - 08-16-2013, 06:36 AM
RE: Getting carried away - by DaveH - 08-16-2013, 07:07 AM
RE: Getting carried away - by Dave J - 08-16-2013, 07:15 AM
RE: Getting carried away - by DaveH - 08-16-2013, 09:03 AM
RE: Getting carried away - by Micktoon - 08-16-2013, 03:16 PM
RE: Getting carried away - by doubleboost - 08-16-2013, 03:45 PM
RE: Getting carried away - by EdK - 04-18-2014, 12:52 PM
RE: Getting carried away - by Dave J - 04-18-2014, 04:30 PM



Users browsing this thread: 1 Guest(s)