Cutting an Internal Thread on the Atlas Lathe
#11
Hi Tom,, more cracking videosSmiley-dancenana , its advice like the matter of the 30 degrees not mattering in practical terms over the 29 degrre setting that really helps people starting off. I will be interested to see if others comment on how noisey the Atlas was in back gear, it seemed loud on the video.
I hope you have many more videos planned Tom, you do a good job of explaining things, thanks again Mick

If you were local I would take you for few beers , then you could blame your drinking on me Rotfl
Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)