Antique cast iron clamp part fixed
#1
A guy at work dropped this part off and asked if i could weld it. Yup no problem i said. Fired up the MM185 with crown alloys .035 cast wire and 75/25 gas and tacked it together. Ran some beads and cleaned it up...Bob


Attached Files Thumbnail(s)
           
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:
#2
That must have made your customer happy. Nice job. Thumbsup

Ed
Reply
Thanks given by: aametalmaster
#3
Nice repair Bo. Didn't know there was wire available for repairing cast, I've only ever used stick.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by: aametalmaster
#4
a job well dun
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by: aametalmaster
#5
(09-08-2013, 07:54 PM)f350ca Wrote: Nice repair Bo. Didn't know there was wire available for repairing cast, I've only ever used stick.

And i have been waiting 30 years for it...Bob


Attached Files Thumbnail(s)
   
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)