|
Soft jaws for a 3 jaw chuck
|
 (09-15-2013, 08:14 AM)EdK Wrote: http://www.metalworkingfun.com/showthread.php?tid=1237  Steve did you chop an inch off of your lathe bed? Last time it was a 12 x 37 lathe.  On a more serious note: You did an excellent job of reworking those jaws.   What kind of jobs would you normally use the soft jaws for?
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Soft jaws for a 3 jaw chuck - by stevec - 09-15-2013, 07:21 AM
RE: Soft jaws for a 3 jaw chuck - by EdK - 09-15-2013, 08:14 AM
RE: Soft jaws for a 3 jaw chuck - by Highpower - 09-15-2013, 09:56 AM
RE: Soft jaws for a 3 jaw chuck - by EdK - 09-15-2013, 03:42 PM
RE: Soft jaws for a 3 jaw chuck - by stevec - 09-15-2013, 03:46 PM
RE: Soft jaws for a 3 jaw chuck - by stevec - 09-15-2013, 03:22 PM
RE: Soft jaws for a 3 jaw chuck - by EdK - 09-15-2013, 03:36 PM
RE: Soft jaws for a 3 jaw chuck - by stevec - 09-15-2013, 03:47 PM
RE: Soft jaws for a 3 jaw chuck - by EdK - 09-15-2013, 04:31 PM
RE: Soft jaws for a 3 jaw chuck - by Mayhem - 09-15-2013, 10:27 PM
|
