Cutting Speed and RPM on the Lathe and Mill
#10
Thanks David.

Ken, I never know how much detail to include in the videos. It's nice to know the background behind some of these common formulae, but at some point eyes start to glaze over. Blink

Andy, I agree with Darren, the easiest way to apply this formula to metric end mills is to just convert their diameters to inches.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
RE: Cutting Speed and RPM on the Lathe and Mill - by TomG - 10-01-2013, 10:26 AM



Users browsing this thread: 1 Guest(s)