|
Lathe advice
|
|
11-24-2013, 01:02 AM
Yeah, Tom. But you're talking about wood over concrete. Shawn's new place, IIRC, had the originally intended shop area with a wood-framed floor. At that time, he was careful of the weight of the machines. Lots more tonnage since then.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Lathe advice - by Shawn - 11-21-2013, 02:00 AM
RE: Lathe advice - by awemawson - 11-21-2013, 04:29 AM
RE: Lathe advice - by tekfab - 11-21-2013, 03:30 PM
RE: Lathe advice - by TomG - 11-21-2013, 09:40 PM
RE: Lathe advice - by Hawkeye - 11-23-2013, 06:15 PM
RE: Lathe advice - by TomG - 11-23-2013, 07:40 PM
RE: Lathe advice - by Hawkeye - 11-24-2013, 01:02 AM
RE: Lathe advice - by awemawson - 11-24-2013, 03:50 AM
RE: Lathe advice - by Shawn - 11-24-2013, 03:56 AM
RE: Lathe advice - by stevec - 11-24-2013, 08:19 AM
RE: Lathe advice - by wrustle - 11-24-2013, 09:19 AM
RE: Lathe advice - by Sunset Machine - 11-24-2013, 11:06 AM
RE: Lathe advice - by Shawn - 11-24-2013, 12:41 PM
RE: Lathe advice - by Hawkeye - 11-24-2013, 07:30 PM
RE: Lathe advice - by Shawn - 11-24-2013, 07:39 PM
|
