MetalworkingFun Forum › Machinery › Lathes v
Tangential Toolholder

Thread Modes
Tangential Toolholder
the artfull-codger Offline
Sophmore
***
Posts: 184
Threads: 21
Joined: Feb 2013
Location: north yorkshire n.e.england
#12
12-27-2013, 01:22 PM
(12-27-2013, 06:37 AM)Arbalest Wrote: Glad you liked it Graham. It's takes a little care to get it spot-on but once made saves a lot of time.

You might want to recess the base a little to help ensure it stands flat:

[Image: IMGP2128_zpsfcbd6207.jpg]

It's not just another height setting guage is it ?? a recess in the base, polished body & the turned slot looks like it's sandblasted & the corners nicely machined off!! yes I like quality!! 6799
Graham.
the artfull-codger, proud to be a member of MetalworkingFun Forum since Feb 2013.
Reply
Thanks given by:


Messages In This Thread
Tangential Toolholder - by Hawkeye - 12-25-2013, 12:42 AM
RE: Tangential Toolholder - by Arbalest - 12-25-2013, 05:58 AM
RE: Tangential Toolholder - by TomG - 12-25-2013, 02:22 PM
RE: Tangential Toolholder - by Hawkeye - 12-25-2013, 11:53 PM
RE: Tangential Toolholder - by Arbalest - 12-26-2013, 02:28 AM
RE: Tangential Toolholder - by the artfull-codger - 12-26-2013, 05:28 PM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 04:45 AM
RE: Tangential Toolholder - by the artfull-codger - 12-27-2013, 06:15 AM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 06:37 AM
RE: Tangential Toolholder - by the artfull-codger - 12-27-2013, 01:22 PM
RE: Tangential Toolholder - by Hawkeye - 12-27-2013, 11:43 AM
RE: Tangential Toolholder - by EdK - 12-27-2013, 12:18 PM
RE: Tangential Toolholder - by aRM - 05-09-2015, 11:40 PM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 03:57 PM
RE: Tangential Toolholder - by how'sitwork? - 05-06-2015, 04:57 PM
RE: Tangential Toolholder - by Arbalest - 05-10-2015, 04:28 AM



Users browsing this thread: