Quick Change Toolpost for Storebro
#43
Steve, the steel is good ol' mystery metal from the scrappers, hot roll processed. Not the nicest finish, but workable.

Pix, I haven't tried it yet, but you have to have one to try it, so it made the list. Actually, I don't know how useful it will be, since the lathe isn't made to stop at a shoulder. I'm more likely to do SAE threads anyway, so I'll need to make a threading dial so I can drop off the half-nuts.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by: stevec


Messages In This Thread
Quick Change Toolpost for Storebro - by Hawkeye - 12-31-2013, 12:46 AM
RE: Quick Change Toolpost for Storebro - by TomG - 01-07-2014, 12:12 PM
RE: Quick Change Toolpost for Storebro - by Shawn - 01-01-2014, 05:42 AM
RE: Quick Change Toolpost for Storebro - by EdK - 01-03-2014, 12:33 PM
RE: Quick Change Toolpost for Storebro - by Shawn - 01-19-2014, 03:23 AM
RE: Quick Change Toolpost for Storebro - by Hawkeye - 02-08-2014, 10:49 PM



Users browsing this thread: 1 Guest(s)