a spill pot revamp
#1
hi all not bin up to much bin too busy with work any way i have bin getting told off for not posting out so he goes well i first chum a Cross one of these on john's posts a spill pot mmm i think i can mack one of them but fate intervened out shopping for sum bubbles for me grand sun came a Cross one of these see pic for the sum total of 49p i have plenty of brushes see pic but the Handel is a bit to short and don't like the brush siting on the bottom had a rut on me shelves and fawned this its a fixing screw that holds me cars iner wheel arch in place just the right sis to fit the brush to keep it of the bottom and also keep muck out of the pot all dun ha if only if you see in the pick the lid ant flat on the under side so when lade over it runs out so much for bin anty spill any way a anther rut on me shelves i have sum silicon tubing the type used on model engines made a ring to fit in side the lid ha presto no leeks any way pics


Attached Files Thumbnail(s)
                               
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#2
Nie job , Bob , I keep forgetting to look for these when I am at the shops, looks like the basic pots as supplied still need to be adapted to make them any good, looks like you have got it sussed out though, cherrs for posting Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#3
Graemlin
Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)