Colchester Bantam Lathe
#1
hi guys
i am looking to buy a COLCHESTER BANTAM LATHE it is being sold with standard imperial thread cutting gears would anyone know what transision gears i would need to cut metric threads
thanks

IAN
PLUTO, proud to be a member of MetalworkingFun Forum since Feb 2014.
Reply
Thanks given by:
#2
Ian, firstly Smiley-signs046

And secondly, the only transition gear I know of would be a 127 tooth gear but I don't know what metric pitches the transitioned TPI settings would produce. Someday I may have to do the math but so far any metric threading has been done on my 16x60 which has both metric and inch pitches on its threading charts.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#3
Welcome to the forum Ian.

Which version of the Bantam is it?

http://www.lathes.co.uk/bantam/

Ed
Reply
Thanks given by:
#4
(02-19-2014, 08:40 AM)EdK Wrote: Welcome to the forum Ian.

Which version of the Bantam is it?

http://www.lathes.co.uk/bantam/

Ed

I think it would be the MK1 800 RPM with 30" centers.
I am just looking at it as the lathe I have is 100 years old and has no metric it's a Lang of Jonstone Glasgow.
PLUTO, proud to be a member of MetalworkingFun Forum since Feb 2014.
Reply
Thanks given by:
#5
Hi
Ian
I had the same lathe
You need the 100 / 127 gear to convert ether way
Welcome to the forum Smiley-eatdrink004Smiley-eatdrink004Smiley-eatdrink004
John
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)