32x40 H Gas Engine
#31
This stage is to make the front plate of the crank case, this will allow me to assemble the barrel and liner and use it as a jig so I can bore the liner to size.

So bore the front plate to the OD of the liner.

   

   

Next operation will be to fit the studs to clamp the barrel to the front plate,

Slowly slowly Brian.Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#32
The front plate was marked out using the odd jaw calipers,center punched
and the marks enlarged with the Archimedes drill.

   

The holes drilled tapping size, then transferred to the barrel for tapping and then the plate holes enlarged to clearance size.

   

Brian.Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#33
Looking real good Brian. Your flying along with this build.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#34
Smiley-signs009 I enjoy watching your progress.

Ed
Reply
Thanks given by:
#35
The uninformed (me) would like to be informed about " the Archimedes drill" . it looks like it may be like a "YANKEE PUSH PULL Drill "
Am I even close ?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#36
Hi Steve
Archimedes invented his drill about the time when the Indians ruled America.
It's very useful for enlarging center marks, it even allows you to correct marks that are off by angling the drill.
Yes it's a push pull drill some have a spring return. It's one of my favorite tools.
Brian
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by: stevec
#37
The next stage was to fit the head blank in the same manner that the front plate was fitted, this now gives me a full set of bolt holes so I can assemble the barrel and liner with it's gasket and "o" ring, (but without the head) and mount it on the mill to final finish the liner bore. Just waiting for the "o" ring.

   

Brian.Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#38
The next job was to cut the 45° space for the "O"ring.

   

Then the assembled barrel and liner was set up in the mill To finish the bore. It took a lot of passes to get the taper out of the bore caused by the tool springing. I am so glad I modded the X to power feed.

   

   

The piston was then turned to size and lapped to fit.

   

   

Rings to get, and grooves to cut, then it can come off the mandrel to do the inside.

Brian.Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#39
Excellent job Brian, looking good Thumbsup Worthy
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#40
It's coming along well Brian. Thumbsup

I'll bet that cast iron is fun to machine.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)